How do I enable wireless encryption on my DGL-4300?
Wireless encryption will only allow wireless clients to
connect to your DGL-4300 that have the correct encryption key.
The DGL-4300 supports the below methods of wireless encryption:
· None
· WEP
· WPA
·
WPA-PSK
None
NOTE: None is the default setting.
Step 1 Open a web browser and type the IP address of the DGL-4300 in the
address (default is 192.168.0.1). Press Enter.
Step 2 The default password is blank (nothing). Click Log In.
Step 3 Click Wireless Security on the left side.
Step 4 In the Wireless Security Mode section select None.
Step 5 Click Save Settings at the top to save the new settings.
WEP
Step 1 Open a web browser and type the IP address of the DGL-4300 in the
address (default is 192.168.0.1). Press Enter.
Step 2 The default password is blank (nothing). Click Log In.
Step 3 Click Wireless Security on the left side.
Step 4 In the Wireless Security Mode section select WEP.
Step 5 In the WEP section configure the following:
- WEP Key Length - Select the key length (64-
or 128- bit).
- WEP Key 1-4 - Enter the WEP Key in one of the 4 WEP key
text boxes. WEP keys are case sensitive and must be the same on all
wireless clients.
- Default WEP Key - Select the WEP Key that
you want to use to secure your wireless network. If you select WEP Key 1,
then you need to configure all wireless clients to use WEP Key 1.
- Authentication - Select Open or Shared
Key. An open key will allow all wireless clients to communicate
with each other. A shared key will only allow wireless clients with
that share the same WEP key to communicate with each other.
Step 6 Click Save Settings at the top to save the new settings.
WPA
Step 1 Open a web browser and type the IP address of the DGL-4300 in the
address (default is 192.168.0.1). Press Enter.
Step 2 The default password is blank (nothing). Click Log In.
Step 3 Click Wireless Security on the left side.
Step 4 In the Wireless Security Mode section select WPA-Enterprise.
Step 5 In the WPA section select TKIP or AES next
to Cipher Type and enter the Group Key Interval Update (in
seconds).
Step 6 Enter the settings for your radius server in the EAP (802.1X)
section.
Step 7 Click Save Settings at the top to save the new settings.
WPA-PSK
Step 1 Open a web browser and type the IP address of the DGL-4300 in the
address (default is 192.168.0.1). Press Enter.
Step 2 The default password is blank (nothing). Click Log In.
Step 3 Click Wireless Security on the left side.
Step 4 In the Wireless Security Mode section select WPA-Personal.
Step 5 In the WPA section select TKIP or AES next
to Cipher Type and enter the Group Key Interval Update (in
seconds).
Step 6 In the Pre-Shared Key section, enter the pre-shared key.
Step 7 Click Save Settings at the top to save the new settings.